Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Fontana, CA
Chimney repair in Fontana usually means working on a 20 to 40-year-old prefab metal fireplace, not a hand-built masonry chimney. The city’s housing stock exploded between the 1980s and 2000s, and nearly all of those stucco tract homes in ZIPs 92336 and 92337 have factory-built chimney systems that crack, rust, and leak in ways older brick chimneys don’t. We see the same handful of problems across Fontana: rusted chase covers, wind-damaged caps, cracked refractory panels, and flashing that gave up after a few dry Santa Ana seasons. If your chimney has never been touched since the house was built, call Mayflower Chimney Sweep at (877) 819-0285 and we’ll tell you straight what’s going on.
Why Fontana Homes Are Different
Fontana sits right where the Cajon Pass funnels dry wind down into the Inland Empire. Those Santa Ana gusts don’t just coat patios with dust, they peel lightweight flue caps off prefab chimneys and drive grit into every seam and chase cover. A 1990s subdivision roof with a capped chase and no storm collar is a water leak waiting to happen, and we see it constantly in 92336 and 92337. The long, hot summers bake creosote and soot inside flues until they harden like lacquer. Then fall hits and families in the older 92335 neighborhoods near downtown light their first fire of the season in a chimney that hasn’t been inspected since the Clinton administration.
Most Fontana chimneys are prefab metal units because the city’s big growth came after the 1970s, when factory-built fireplaces became standard in California tract housing. That changes the repair work significantly. You’re rarely rebuilding a brick crown here. You’re replacing rusted chase covers, swapping cracked refractory panels, and installing proper caps on metal flues. The houses near the 92331 and 92336 edges of town, built in the 1980s and 1990s, show the most wind exposure damage because they’re closest to the open pass corridors.
Styles & brands we work with
Our Main Fontana Services
Fontana homeowners call Mayflower Chimney Sweep for two jobs more than anything else: a thorough chimney sweep before the fall burning season, and a dryer vent cleaning they’ve been putting off for years. Both are fire-safety maintenance, and both are handled by the same crew.
Chimney Sweep in Fontana
A proper sweep in Fontana means more than running a brush up the flue. The dust and grit that blow through the Cajon Pass during wind season settle inside chimneys all summer, mixing with creosote and soot that baked hard in the heat. We remove that buildup, check the cap and chase cover for wind damage, and inspect the refractory panels inside your prefab fireplace for hairline cracks. Most Fontana homes haven’t had a sweep since they moved in. If you’re in that group, it’s time. Read more about our Chimney Sweep in Fontana service, including how we work around your schedule.
Dryer Vent Cleaning in Fontana
Your dryer exhaust is a chimney too, it carries hot air and lint out of your house, and in Fontana’s dry climate that lint builds up fast. We clean the full vent run from the dryer to the outside termination, which reduces a serious household fire risk and helps your dryer actually dry clothes instead of running extra cycles. Homes in 92337 with long horizontal vent runs through the garage or under the slab need this most. See our Dryer Vent Cleaning in Fontana page for what the job includes and what it costs.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Fontana
Chimney repair in Fontana is typically about prefab fireplace systems, not masonry. The tract homes built between 1980 and 2010 in 92336 and 92337 almost all have factory-built metal chimneys, and after 20 or 30 years of Santa Ana winds and baking summer heat, the metal components fail. What starts as a missing cap or a rusted chase cover turns into water dripping down the flue, staining the ceiling, and cracking the firebox panels. Most Fontana homeowners don’t know they have a problem until lighting season starts. Our Chimney Repair work addresses the full factory chimney system, from the chase cover at the roofline to the refractory panels inside the firebox.
Chimney Cap Installation
Signs you need it
If you can see daylight down your flue from the roof or hear wind whistling through the fireplace on a Santa Ana day, your cap is gone or never existed.
What it costs in Fontana
A new chimney cap installation in Fontana typically runs $220 – $500 depending on whether we’re fitting a standard single-flue cap or a custom multi-flue cap for a prefab chase cover.
How we do it
We measure the flue opening, select a correctly sized cap, and secure it with mechanical fasteners or a compression fit so wind off the Cajon Pass won’t take it.
Chimney Cap Replacement
Signs you need it
A cap that’s dented, rusted through, or missing entirely means rain and birds have open access to your flue.
In Fontana’s dry wind, caps corrode or blow off regularly, and a replacement runs $200 – $500 for most single and multi-flue prefab setups.
How we do it
We remove the damaged cap, inspect the flue edge for rust, and install a new cap sized to your specific flue with a storm collar where the chase terminates.
Chimney Liner Installation
Signs you need it
If your prefab chimney shows rust streaks inside the chase or your fireplace smokes back into the room, the liner sections may have separated or corroded.
What it costs in Fontana
For a true liner installation or replacement on a Fontana prefab system, expect a range of $2,900 – $7,500 depending on flue height and whether we’re using a DuraFlex-style flexible liner or rigid sections.
How we do it
We document the existing flue condition with photos, recommend a correctly sized liner, and install it with a top plate and cap so the system vents properly from firebox to roofline.
Chimney Flashing Repair
Signs you need it
Water stains on the ceiling near your fireplace or damp drywall around the chase are the classic signs that flashing has pulled away from the roof deck or the chase.
What it costs in Fontana
Chimney flashing repair in Fontana runs $250 – $750 depending on how much of the existing flashing needs to be replaced and whether the chase penetration is on a steeper roof slope.
How we do it
We remove the old flashing, inspect the roof penetration for rot or gaps, and install new flashing sealed with high-temp outdoor sealant so water flows around the chimney instead of into it.
Chimney Crown Repair
Signs you need it
Cracks in the concrete or mortar crown on a masonry chimney let water penetrate the flue system, and in Fontana’s rare hard rains that water finds its way inside fast.
What it costs in Fontana
For masonry crowns on the few true brick chimneys in Fontana, expect $400 – $900 for crack repair or a full crown rebuild.
How we do it
We clean out the cracked areas, fill and seal with a proper crown repair compound, or strip and rebuild the crown with a slight slope so water drains away from the flue.
What Chimney Repair Costs in Fontana
| Item | Typical range in Fontana |
|---|---|
| Chimney cap replacement | $200 – $500 |
| Chimney flashing repair | $250 – $750 |
| Chimney crown repair | $400 – $900 |
Do I really need a new liner, or will a repair hold?
It depends on what the photos show. Most Fontana prefab chimneys don’t have a traditional masonry liner to replace, they have interlocking metal flue sections. If the sections are rusted through or separated, patching won’t hold and a new liner is the honest repair. We show you the pictures before you spend anything.
How long does chimney repair take in Fontana?
Most cap, flashing, and crown repairs are done in a single visit, two to three hours on site. Full liner installations on taller two-story Fontana chases can run five to seven hours. We’ll give you a straight time estimate before we book the work.
Brands We Service in Fontana
We stock and install chimney components from DuraFlex, Olympia Chimney, and Copperfield, which means the cap or liner fix on your Fontana home uses materials you can actually research. No generic knockoffs, no mystery parts. Parts arrive faster when we’re not waiting on a middleman. See our brands for the full list of what we work with.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Fontana, CA
| Service | Typical range in Fontana |
|---|---|
| Chimney sweep | $180 – $280 |
| Level 1 inspection | $149 – $275 |
| Level 2 inspection | $275 – $500 |
| Chimney cap replacement | $200 – $500 |
| Chimney flashing repair | $250 – $750 |
| Chimney crown repair | $400 – $900 |
| Chimney liner installation | $2,900 – $7,500 |
| Dryer vent cleaning | $130 – $190 |
What pushes a Fontana quote toward the higher end of a range is usually access: a steep roof pitch on a two-story tract home, a chase buried behind a stucco wall that needs scaffold work, or a flue that hasn’t been touched in two decades and needs extra cleaning passes before inspection. We quote a flat price before any work starts, and that number doesn’t change unless we find something significant mid-job and you approve the extra in writing.
Neighborhoods We Serve in Fontana
We work all over Fontana, from the older central neighborhoods to the big subdivisions up against the 15 and 210 corridors. Most jobs in the city are reachable on the same route, so we schedule Fontana work in tight windows every week.
- Downtown Fontana (92335)
- Summit Heights area (92337)
- North Fontana subdivisions (92336)
- Sierra Lakes area (92336)
- Southridge and the 92337 corridor
Service Area – Cities Near Fontana
Mayflower Chimney Sweep also covers the surrounding Inland Empire communities with the same flat-price repair and sweep work. We regularly serve Bloomington, CA to the west, Rialto, CA to the north, Glen Avon, CA to the southwest, and Pedley, CA just over the Santa Ana River. If you’re in one of those cities or anywhere in between, the phone number’s the same: (877) 819-0285.
Serving Fontana, CA — Our Local Coverage Area
We’re based in the Fontana area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Fontana
Once a year at minimum, ideally in late summer before burning season. Fontana’s hot dry summers bake creosote hard, and wind-driven debris from the Cajon Pass can block a flue between seasons. An annual inspection catches cap damage and panel cracks before you light the first fire.
Most chimney repairs like cap replacement, flashing, and crown work don’t require a city permit in Fontana. If you’re in an HOA-governed subdivision in 92336 or 92337, check your CC&Rs for exterior appearance rules, but the actual repair work is straightforward. We can tell you what your specific scope involves when we quote.
Yes. We often repair first and sweep after, since removing a damaged cap or opening up a chase can introduce debris into the flue. The work order gets sequenced so you’re not paying for two visits. Call (877) 819-0285 and we’ll sort out the order that makes sense for your chimney.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Fontana Customers Say
"Crown was cracked and taking water. Repaired it rather than quoting a rebuild, which the previous company had pushed hard for."
— Henry Nguyen"Drop cloths everywhere, HEPA vac, and not a speck of soot on the carpet. I'd been dreading the mess for nothing."
— Shane Ziegler"Creosote buildup was worse than I realized. He measured it, showed me the glazing on the flue with the camera, and was honest that we were closer to a chimney fire than I wanted to hear."
— Alejandro Vargas