Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Dryer Vent Cleaning Across Fontana
A dryer vent cleaning in Fontana typically costs $89 – $165 for a standard single-story home, takes 45 – 90 minutes, and removes the lint accumulation that accounts for roughly 2,900 house fires nationally each year. We work throughout Fontana ZIPs 92335, 92336, 92337, and 92331, including the older tracts near Sierra Avenue and the large stucco subdivisions east of the 15. Nolan Crisp and our team at Mayflower Chimney Sweep handle every vent as a fire-prevention job, not a courtesy add-on, because a clogged dryer vent behaves like a small chimney fire waiting for the right conditions. Call (877) 819-0285 to schedule.
Why Mayflower Chimney Sweep Is Fontana’s Preferred Dryer Vent Cleaning Company
Fontana’s housing stock has a particular profile: thousands of tract homes built between 1985 and 2005, many with laundry closets on the second floor or vents running long horizontal distances through walls before they exit the exterior. Those runs catch lint fast. Our crew has pulled enough compacted lint from 92336 and 92337 homes to know exactly where the restrictions happen and how to reach them without cutting drywall. We also see the connection other companies miss. When a Fontana home has a prefab fireplace that has never been inspected and a dryer that suddenly takes two cycles to dry clothes, the two problems are often related to one shared symptom: a house that can’t exhale. Our vent cleaning treats the whole exhaust picture.
Dryer Vent Cleaning from our team means we measure airflow before and after the job, show you the lint we removed, and leave the vent pulling the way it did when the house was built. We’re not a two-truck operation that bounces between counties. Fontana is a short drive for us, and we know the building patterns here: the mid-century ranch homes near downtown Fontana and the 1990s stucco boxes in Southridge and Hunter’s Ridge with second-floor laundry rooms that have never seen a brush. We also know the dryer duct materials used in those eras, from foil flex tubing that crushes easily to rigid aluminum runs that hold lint at elbow joints.
And we’re the same company that inspects and repairs chimneys, which matters more in Fontana than people realize. The dry Santa Ana winds that rip through the Cajon Pass tear caps off prefab fireplaces, and that debris finds its way into the same exterior walls where dryer vents terminate. We’ll catch it. Call (877) 819-0285 and we’ll tell you what we find, in plain language, before we touch anything.
Styles & brands we work with
Our Dryer Vent Cleaning Services in Fontana
Dryer Vent Cleaning
A standard vent cleaning in Fontana runs $89 – $165 depending on roof access, vent length, and how long it’s been since the last cleaning. We remove lint from the entire run, from the dryer connection to the exterior termination point, then verify flow with an airflow meter. Most jobs take under 90 minutes, and we leave the laundry room cleaner than we found it. If your dryer sits in a second-floor closet in 92336, expect the vent to run farther than a ground-floor laundry in 92335, and expect more lint packed at the elbows. That longer run is exactly why Fontana dryers often take forever to dry jeans in summer.
Commercial Dryer Vent Cleaning
Fontana has a solid mix of rental housing, small apartment complexes, and a few coin-laundry operations along Foothill Boulevard and Sierra Avenue. Multi-unit dryer vents collect lint faster, and tenants don’t usually think about vent maintenance. We clean multifamily and light commercial dryer exhaust systems, and we can schedule recurring service for property managers in 92335 and 92337 who want documentation for insurance or fire inspection purposes. Pricing for commercial stacks starts around $250 and depends on the number of dryers per riser and roof access.
Dryer Vent Repair & Rerouting
Sometimes the vent isn’t dirty; it’s broken. We find crushed flex tubing, disconnected segments inside walls, and vents that terminate under the house instead of outside. Fontana’s 1980s and early 1990s homes often used white vinyl flex duct that degrades, pinches, and traps lint. We replace it with rigid aluminum or heavy-gauge flex, reroute when a builder put the vent in a bad location, and cap the exterior with a pest-guarded termination. If a dryer has been venting into an attic or crawlspace, that’s a serious moisture and fire problem we correct the same day.
Dryer Vent Inspection
If your dryer is working but the vent hasn’t been looked at in years, an inspection is the place to start. In Fontana, that means checking the run length against manufacturer limits, looking for sagged sections that collect lint, confirming the termination flap opens properly, and checking for lint staining around the wall behind the dryer. We inspect with a camera where access is tight, and we’ll show you the photo. Dryer vents are chimneys too, and just as important to maintain.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Fontana
We work on dryer vents and chimney systems from all major manufacturers, and when a component needs replacing, we install parts from brands we’d put in our own homes. On the vent side, we stock heavy-gauge aluminum elbows, terminations, and connectors. On the chimney side, a Fontana prefab replacement might use Copperfield caps and chase covers, or an Olympia Chimney termination that matches the original factory spec. For relining jobs where a dryer vent scan turns up a cracked prefab flue, we use DuraFlex liners and HeatShield resurfacing materials. We name what we use and stand behind it. If a part number matters to you, we’ll hand you the paperwork.
See the difference
Before
After
Before
After
Before
AfterCommon Dryer Vent Cleaning Problems We See in Fontana Homes
- Long lint-packed runs in second-floor laundry closets. The 1990s subdivisions in 92336 and 92337 put laundry rooms upstairs to save square footage, but that pushes dryer exhaust 20 to 30 feet before it exits. Lint drops out of suspension at every elbow, and after five years, a 4-inch duct can choke down to an inch or less. We clear it and verify airflow with the dryer actually running.
- Crushed foil flex tubing behind the dryer. Builders in Fontana’s faster growth years used cheap foil or vinyl flex because it was quick. That tubing crushes when the dryer is pushed against the wall and then traps lint. We replace it with smooth-wall rigid aluminum where possible, which lint can’t grab as easily.
- Vents that terminate in attics or crawlspaces. We find more of these than you’d believe, especially in older 92335 homes that were retrofitted for dryers. Venting moisture into an attic rots roof decking and grows mold. We reroute the exhaust to a proper exterior termination and seal the old opening.
- Damp lint clogging the termination flap. Fontana’s dry heat bakes lint into a hard cake at the exterior vent cap, and when the flap won’t open, moisture stays inside the duct. That wet lint packs tight and becomes a restricted airflow problem. We remove the cap, clean the full run, and install a pest-guarded termination that opens freely.
Pricing for Dryer Vent Cleaning in Fontana, CA
Here’s what Fontana homeowners can expect to pay. A standard dryer vent cleaning for a single-family home runs $89 – $165. If the vent is on a roof instead of an exterior wall, that pushes toward the higher end. We don’t charge extra for a second-story laundry, but long commercial-style runs or badly deteriorated termination replacement adds parts cost. A full dryer vent inspection with camera documentation is $75 – $125 when booked as a standalone service, and it’s credited toward the cleaning if you do both the same day. For a vent replacement or reroute, Fontana pricing typically falls between $180 and $425 depending on access, run length, and whether we’re cutting into drywall or going through an exterior wall. We give a flat, written estimate before we start, and we don’t recommend anything unless we can show you the problem. Call (877) 819-0285 and we’ll price your exact vent over the phone.
We Also Serve Cities Near Fontana
Our service area covers Fontana and the surrounding Inland Empire communities, including Bloomington, Rialto, Glen Avon, and Pedley. If you’re just outside Fontana city limits in an unincorporated county pocket, call us anyway. we’re usually 20 to 30 minutes out, and we’ll tell you straight if we can make the trip work. We’d rather drive an extra few exits than leave a lint-loaded vent in service.
Serving Fontana, CA — Our Local Coverage Area
We’re based in the Fontana area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs – Dryer Vent Cleaning in Fontana
Yes, and Fontana houses make the case better than most. The 1980s – 2000s tract homes in 92336 and 92337 were built with factory-made metal chimneys, not masonry, and those units have refractory panels that crack from heat cycling. The Santa Ana winds that blow through the Cajon Pass also strip caps off those lightweight prefab flues, leaving the opening exposed to debris and rain. A factory chimney that’s never inspected can show cracked firebox panels, rusted chase covers, or wind-damaged terminations that are invisible from the ground until water stains show up inside. An annual inspection catches those problems before they become a structural repair. If you own a 1990s Fontana home and have never had the prefab chimney looked at, that’s a stronger reason to call, not a weaker one. Call (877) 819-0285 to schedule an inspection.
Hot weather alone doesn’t slow a dryer down. What slows it down is a lint-restricted vent that loses airflow, and Fontana’s long dry summers bake that lint into a compacted layer inside the duct. When the vent can’t push air out, the dryer’s moisture sensor keeps running the cycle longer to try to hit the dryness target. If you notice your dryer running 90 minutes for a load that used to finish in 45, or the laundry room feels humid while the machine runs, the vent is the first place to check. A standard cleaning restores the airflow and usually fixes the extended dry cycle. If it doesn’t, we’ll tell you what else might be wrong. Estimates are free.
Third-degree creosote is the hardened, tar-like glaze that can form on the inner walls of a prefab flue liner, and it’s a different animal from the dusty first-degree creosote a brush easily removes. Fontana homeowners usually notice a strong campfire smell even when the fireplace isn’t burning, or they see a shiny, dark coating when they shine a flashlight up the flue from inside the firebox. Third-degree creosote sometimes drips down onto the smoke shelf and looks like black syrup. In a prefab chimney, you can’t just sweep this away; it often requires chemical treatment or, in severe cases, a liner option like a DuraFlex system. If you see black glaze or smell burnt wood in August, don’t run another fire. Call us for a camera inspection and we’ll show you exactly what’s on the flue walls.
They do it regularly. The Santa Ana winds that funnel through the Cajon Pass and sweep down into Fontana hit lightweight prefab chimney caps with enough force to tear them loose or bend the mounting brackets. On a 1990s tract home in 92336, our tech found a DuraFlex flue cap ripped off by a wind gust, with rainwater already staining the firebox panels below. We installed a new cap with a storm collar and cleared the first-degree creosote from the liner. If your cap is missing, tilted, or rattling on windy nights, the flue is open to water, birds, and debris. We carry replacement caps for most factory chimney brands and can install one the same day we inspect it. Call (877) 819-0285 and we’ll come take a look from the roof.
Because we treat a dryer vent like the fire-safety system it is, and because we’re local enough to Fontana that we know the housing stock and the failure patterns. A crew that only cleans dryer vents misses the connection between a lint-clogged exhaust and a wind-damaged prefab chimney on the same wall. We see both. We stock Copperfield caps, Olympia Chimney parts, and DuraFlex liner components, so when a vent cleaning uncovers a chimney problem, we can address it the same visit. Nolan Crisp built this company around telling people what’s actually wrong in plain language, with camera proof, and no upsell. That’s rare in this trade, and it’s the main reason Fontana homeowners keep our number. Call (877) 819-0285 for a free estimate, and we’ll route a crew your way.
Written by Nolan Crisp, Owner at Mayflower Chimney Sweep, serving Fontana and the Inland Empire.